Could this be any cuter? I couldn’t ‘bear’ it if it was!
Designed for use with the Bear Ears Shaper, but works perfectly fine as a stand alone stamp.
Also a part of the Cute Set.
- Stamps are a print on demand item. Sometimes we have excess ready made and these will be used in your order first, but as a general rule these will be printed when your order comes. Please allow this timing in your orders. Stamps take approximately 2 hours each to print and there may be orders currently printing when yours is placed.
- These items are 3D printed and do not deal well with heat. Do not place in dishwasher. Please make sure to clean using cool water. For best results, leave for 24 hours after using to allow soap to saponify and rinse off using cold water.
- Stamps hold a whole mess of static electricity. Give them a wipe down with isopropyl alcohol and a paper towel to remove any dust or fuzzies they will have inevitably picked up from somewhere in the universe.